Harley Davidson Grip Removal

Parts common to ALL Heated Hand Grip Kits 3 Sealed splice connector 2 70586-93 4 Ring terminal 2 for 10 stud 9857 5 Ring terminal 2 for 64 mm 14 in stud 9858 6 Ring terminal for 79 mm 516 in stud 9859 7 Wire harness extension 267 cm 105 in long 69201703 8 Cable strap black 8 267 cm 105 in long 10006 9 Wire fuse block adapter.

Harley davidson grip removal. Remove the grip by carefully cutting it away from the handlebar using a sharp blade or knife. Once clean wipe the bars with some light oil to help the throttle rotate easier. To remove the old grip not caring whether you destroy it cut off the very end of it.

Remove the old throttle grip from the handlebars and clean the area it covered. Remove the grip by carefully cutting it away from the handlebar using a sharp blade or knife. Slide the new grip onto the handlebar and check that the flanges at the end of the grip line up with the channel in the switch housing.

To remove the grip a slight tug may be necessary to release the index pins in the grip from the receptacle in the seal cap. Using sandpaper and an adhesive solvent clean the handlebar and remove any remaining adhesive or grip fragments. Remove the grip by carefully cutting it away from the handlebar using a sharp blade or knife.

Remove the left grip. Remove the end cap from the existing left handlebar grip if equipped. Attach the throttle open and close cables by inserting the ferrules over the ball ends and into the new grip.

Upon removing the grip check the location of the seal cap. IF YOU APPRECIATE THESE FREE DIY VIDEOS PLEASE CONSIDER SUPPORTING US ON PATREON TO ASSURE WE KEEP RELEASING THEM. In this particular video we installed Roland Sands Tracker Grips For Harley Fly-By-Wire on a 2016 Harley Dyna Low Rider S.

Once the grip is off wrap the string around your handlebars and use a ruler to find the diameter of your handlebars. Once aligned remove the grip and apply adhesive to the inside of the grip. The grip is going to be secured by a glue which means that youll have to do some work to get this one removed.